Introduction

Dry Application

1. Clean the surface of the sounder - do not use abrasive materials.
2. Remove the sticker from its backing sheet.
3. Place one edge of the sticker on to the bell box and carefully apply the sticker working away from the attached edge, while attempting to remove any air bubbles. Be careful not to damage the printed surface by over-rubbing.
4. Ensure that the edges are stuck down to prevent moisture ingress to the rear of the sticker.

Wet Application

1. Clean the surface of the sounder - do not use abrasive materials.
2. Half fill a bottle with cold water and add a few drops of washing up liquid.
3. Shake the bottle hard such that the top half of the bottle fills with soap suds.
4. Pour the solution into a suitable tray or dish.
5. Remove the sticker from its backing sheet - retain the backing sheet.
6. Dip the sticker into the soap solution.
7. Place the sticker onto the surface of the sounder and then place the original backing sheet on top of it and, using a rubber squeegee or similar, remove the water from behind the sticker.
8. Dry off any excess moisture and leave to dry - within 2 hours the sticker will be firmly attached.